ASTM E1554/E1554M-13(2023) PDF
Original price was: $69.00.$34.00Current price is: $34.00.
Standard Test Methods for Determining Air Leakage of Air Distribution Systems by Fan Pressurization
ASTM International , 10/01/2023
File Format: PDF
- Description
Description
ASTM E1554/E1554M-13(2023) PDF
1.1The test methods included in this standard are applicable to the air distribution systems in low-rise residential and commercial buildings.
1.2These test methods cover four techniques for measuring the air leakage of air distribution systems. The techniques use air flow and pressure measurements to determine the leakage characteristics.
1.3The test methods for two of the techniques also specify the auxiliary measurements needed to characterize the magnitude of the distribution system air leakage during normal operation.
1.4A test method for the total recirculating air flow induced by the system blower is included so that the air distribution system leakage can be normalized as is often required for energy calculations.
1.5The proper use of these test methods requires knowledge of the principles of air flow and pressure measurements.
1.6Three of these test methods are intended to produce a measure of the air leakage from the air distribution system to outside. The other test method measures total air leakage including air leaks to inside conditioned space.
1.7The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.8This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 7.
1.9This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.